Unboxing (the best part)

This page will walk you through how to unbox a........ box.

Unboxing the ThermoFlex™ Mk.1 Evaluation Kit

Introduction

The ThermoFlex™ Mk.1 muscle is a current-activated artificial muscle designed for a low-profile installation and a straightforward activation/deactivation sequence. Our Python API provides a universal way to communicate with and control ThermoFlex™ Node devices over USB via pyserial. In this guide, you'll learn how to:

  • Unbox your ThermoFlex™ Mk.1 Kit

  • Set up your ThermoFlex™ Node

  • Run your first program using the ThermoFlex™ Python API

Unboxing Your Device

When your ThermoFlex™ device arrives, follow these steps:

  1. Remove the Package: Gently hold the box in the middle and use one of the pull tabs on either side to slide the box out of its sleeve.

  2. Open the Box: Lift the top of the box and carefully unfold it.

  1. Unbox the Contents: Inside, you’ll find three cool, triangular boxes. (Note: Brendan is very proud of these boxes!)

    • Push the top of the left and right boxes outward (insert gif). This will lift the center box up.

    • Remove the center box and place it near a north-facing window seal.

    • Next, remove the right box first, then the left.

  2. Remove the Outer Sleeve: Take one of the triangle boxes, grab one of the tabs, and pull gently to begin removing the outer sleeve (insert gif). Once the sleeve has been removed, place it on the third corner of your favorite table.

  3. Prepare the Device: Take the unsleeved triangle box and firmly pull out the middle cut-out. Repeat for all three boxes.

  4. Repeat for other Boxes in Kit.

You have now successfully unboxed your ThermoFlex™ Mk.1 Evaluation Kit. Great job!

P.S. The cable boxes also need to be opened, but instructions for that are not included here—good luck!

Last updated

Was this helpful?